Spektrum SPMR55001 DX5e Manual Manual de usuario Pagina 9

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 67
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 8
9SPEKTRUM DX5e • RADIO USER’S GUIDE
EN DE FR IT
4. Pull and hold the trainer switch on the top of the
transmitter while turning on the power switch. Release
the trainer switch once the LEDs on the front of the
transmitter flash, and a series of tones are heard.
Within a few seconds the system should connect.
Once connected the LED on the receiver will go solid
indicating the system is connected.
Note: Continuing to hold the trainer switch during the
binding process will prevent preset failsafe positions
from being learned by the receiver.
5. Remove the bind plug from the BATT/BIND port on the
receiver before you power off the receiver and store it in
a convenient place.
6. After you’ve set up your model, it’s important to rebind
the system so the true low throttle and neutral control
surface positions are programmed.
HOW TO RANGE TEST THE DX5E
Before each flying session, and especially with a new
model, it is important to perform a range check. The DX5e
incorporates a range testing system which, when placed in
the RANGE CHECK mode with the trainer switch activated
and held, reduces the output power, allowing a range check.
RANGE TESTING THE DX5E
1. Withthemodelrestrainedontheground,stand30
paces(approx.90feet/28meters)awayfromthemodel.
Note: Prior to performing the range check ensure the
correct failsafe stick positions are established.
2. Face the model with the transmitter in your normal
flying position. Pull and hold the trainer switch while
toggling the HI/LO Rate Switch four times. The LEDs
will flash and the alarm will sound indicating the system
is in range check mode.
Note: The trainer switch must be held the entire time
during the range check process; releasing the trainer
switch will exit the range check mode.
HI/LO Rate Switch
Trainer Switch
3. Youshouldhavetotalcontrolofthemodelwiththe
trainerswitchpulledat30paces(90feet/28meters).
4. If control issues exist, call the Horizon Product
SupportTeamat18775040233orgoto
horizonhobby.com to find a local Spektrum
distributor for service in your country.
30 paces (90 feet/28 meters)
Vista de pagina 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 66 67

Comentarios a estos manuales

Sin comentarios