Spektrum DX9 Manual de instrucciones descargar pdf (Pagina 36)

36 SPEKTRUM DX9 • TRANSMITTER INSTRUCTION MANUAL

Swashplate

The Swashplate menu option enables you to adjust the following:

• SwashplateMix

• Exponential

• E-Ring

• ElevatorCompensation

UsepositiveornegativeSwashplatemixvaluesasneededfor

correct direction response of the helicopter.

BeforemakingadjustmentstotheSwashplatemix,makesurethe

throttle/collective pitch input moves the entire swashplate up or

down. If the servos are not moving in the same direction, reverse

them as necessary in the Servo Setup menu option.

When the entire swashplate moves up or down:

1.AdjustthemixvaluefortheAileronandElevatorchannels.If

the servos do not move in the correct direction, change the

directionofthemix—forexample,apositivevalueinsteadof

a negative value.

2.AdjustthemixvalueforthePitch.Iftheswashplatedoesnot

move in the correct direction, change the direction of the value

(negative instead of positive).

AlwaysenableExpowhenusingastandardrotating-armservo.

TheExpodeliverslinearmovementoftheswashplatefroma

standardrotaryservo.WhenExpoisinhibited,thearmona

rotary servo moves on a curved path with decreased swashplate

movementattheextremesoftheservoarmtravel.

NOTICE: DonotenableExpowhenusingalinearservo.

Electronic E-Ring

This feature prevents over driving servos by limiting servo travel if

thesumofyourcyclicandpitchinputsexceedsservolimits.

Gyro

The Gyro menu option enables you to assign a gyro gain value

to an independent switch or a Flight Mode. Assign the receiver

channel connected to the gyro, then assign the switch for gyro

options. You can also assign values to available switch positions

(from 1 to 5 rates are available, depending on the switch

assigned). Make sure the gyro operates correctly and

compensates in the correct direction.

Governor

The governor function is used to set the rotor head speed when

used with a governor installed in the helicopter. The governor

onboard will control the engine RPM to maintain the head speed

desired. You can program values for each switch position or ﬂight

mode. RPM values can be programmed in 0.5% steps.

To Program the Governor Function:

1. Access the Governor menu option.

2. Program the RPM values by rotating the scroll wheel to the

desired value.

3. Press the scroll wheel and rotate it to the desired value. Press

the scroll wheel again to save the value.

IMPORTANT: The value in the display is the corrected value.

0%is1.5msorOFFformostgovernors.Repeatthisforall

governor settings.

4. Assign the output channel for the Governor. The Governor and

the Gyro must be on different channels. We recommend using

AUX2 for the Governor output channel.

5. Select a switch to control the Governor.

6. Press the BACK button to save the selections and return to the

Function List.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 47 48

Comentarios a estos manuales

Sin comentarios

Spektrum DX9 Manual de instrucciones Pagina 36

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos Spektrum DX9