Spektrum DX9 Manual de instrucciones Pagina 28

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 48
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 27
28 SPEKTRUM DX9 • TRANSMITTER INSTRUCTION MANUAL
EN
Mixing
Mixing allows control input for a channel to affect more than
one channel at a time. Mixing functions support:
• Mixingachanneltoanotherchannel.
• Mixingachanneltoitself.
• Assigningoffsettoachannel
• Linkingprimarytosecondarytrim.
These mixes are available for each model memory:
Select a channel for master and slave. Inputs for the master
channelcontrolboththemasterandslavechannels.Forexample,
Elevator to Flap makes elevator the master channel and flap the
slave channel.
• 10programmablemixes
• CyclictoThrottle(HELI)
• Swashplate (HELI)
• ElevatortoFlap(ACRO)
• AilerontoRudder(ACRO)
• RuddertoAileron/Elevator(ACRO).
• Aileron>Rudder (SAIL)
• Aileron>Flap (SAIL)
• Elevator>Flap (SAIL)
• Flap>Elevator (SAIL)
Offset
Changetheoffsetvaluetomovetheeffectivecenterposition
of the slave channel. Positive or negative value determines the
directionoftheoffset.Offsetisnotavailableforcurvemixes.
Trim
If the master channel trim should also adjust the slave channel,
set Trim to Act. A channel monitor on the left side of the screen
shows how channels respond to input. To view a switch-assigned
mixonthemonitor,themixswitchmustbeintheactiveposition.
Assigning a Mix to a Switch
If you wish to assign a mix to a switch position:
1.Makesureyouareinthedesiredmixscreen.
2.Movetheswitchyouwanttoassignthemixto.
3.Scrolltotheswitchpositionwhereyouwantthemixtobe
active.
4.Pressthescrollwheeltoactivatethemix.Whentheboxis
lled,themixisactive.
ThemixisActivewhentheboxislledandInactivewhenthe
boxisopen.Youcanassignamixtobeactiveinmultipleswitch
positions (0,1 or 2).
Tip: Use Auto Switch Select to select the switch.
CAUTION: AlwaysdoaControlTestofyourmodelafter
changingmixes.
Back Mixing
BackMixingappliesamixtoallrelatedservosinawingortail
type.Forexample,ifyouselect2AIL,2FLAPintheAircraftType
screen,amixtooneaileronchannelaffectsbothaileronservos.
Themixresponse,however,dependsontheaileronchannel
includedinthemix.
ABackMixalsoenablesyoutousefewermixestoachievethe
desiredresponse,forexampleaddingrolltoasplitelevator.
Vista de pagina 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Comentarios a estos manuales

Sin comentarios